bath solution
英 [bɑːθ səˈluːʃn]
美 [bæθ səˈluːʃn]
电解液，（电镀）槽液
双语例句
- The saccharide determination methods in enzymatic unhairing bath solution were compared.
比较了测定酶法脱毛液中糖含量的分析方法。 - Observation on effect of fumigating washing and hip bath with traditional Chinese herbs and potassium permanganate solution to prevent leukemia patients from perianal infection
中药与高锰酸钾溶液熏洗坐浴防治白血病肛周感染的效果观察 - Causes of the stray current corrosion in inlet and outlet of the electrolytic bath were analyzed to put forward a solution.
分析了电解槽进出口系统各主要设备杂散电流产生原因，提出了针对性的解决方案。 - The effects of the parameters of alternating electric field on the growth of passive film and the dissolution of alloying element in stainless steel were studied by analysis of the composition of passive film and the bath solution.
通过对钝化膜层和溶液中金属离子的含量分析，研究了不同交变电场参数对电极中各金属元素的溶解和沉积。 - Determination of bacteria content in the bath solution of cathodic electrodeposition coatings
阴极电泳涂料槽液细菌含量的测定与防治 - The effects of Cr(ⅲ) concentration on the performances of bath solution and that of hard chromium deposit were studied.
采用镀硬铬溶液，用电解法改变镀液中Cr3+的含量，考察Cr3+浓度对硬铬镀镀液和镀层性能的影响。 - To solve these problems, no measurement whatsoever is needed for the boundary voltage, the conductivity of liquid aluminum and bath solution in the reduction cell.
文中引用相对电压和电位以及相对电导的概念，无需精确地测定电解槽边界电压和电解液、铝液的电导率，即可求解这两类问题，并可提高计算的精度。 - Some essential conditions must be kept to achieve close circulation of electroplating backwash cleaning that including the balance of water amount in system, solute in bath, low incidental solution, concentration controlling of last bath, strict management and maintenance.
提出了在实际生产中，实现电镀逆流清洗闭路循环必须满足系统中的水量平衡、镀液中溶质的平衡、降低镀液带出量、提高末槽控制浓度及严格管理和维护等条件。 - Zn-Mn Electrodeposition in Sulphate-Citric Aicd Bath Solution
硫酸盐-柠檬酸体系锌锰合金电沉积的研究 - Mechanism of Phosphating with High Acidity Bath Solution
高酸度磷化机理分析 - It was determined that water content in bath solution is the most significant factor by quadrature test.
通过正交试验，确定了槽液中水含量是造成槽体严重腐蚀的最显著因素； - Recovery of Bath Solution
电镀溶液的回收 - With an increase of NMMO concentration of coagulation bath or concentration of casting solution, the crystallinity of membrane increases. However, an increase of temperature of coagulation bath is accompanied by a decrease of crystallinity of membrane.
膜的结晶度随铸膜液浓度、凝固浴浓度、刮膜速度的增加而增大，随凝固浴温度的升高而降低。 - Effect of Flow Promotor on Behavior ot Cathodic Electrophoretic Coating and Stability of Bath Solution
流平剂对阴极电泳漆性能和槽液稳定性的影响 - The integrated hippocampal neurons can live 4 hours at least in the standard bath solution.
完整的海马神经元其形态至少可维持4小时以上。 - Disadvantages existed in cathodic electrophoretic painting process in China was pointed out and factors affected the stability of bath solution were discussed. Methods resolving these problems were suggested.
一次阴极电泳涂装质量事故的处理论述了国内阴极电泳涂装中存在的缺点和影响槽液稳定性的因素，提出了解决这些问题的方法。 - Then the THF solution ⅱ was cooled in an ice bath, and a THF solution of triphenylmethyl chloride was slowly dropped into it with stirring for 3 h. 4,4,4-Triphenyl-1-butene(ⅲ) was synthesized in 93% yield.
在冰浴中向Ⅱ缓慢滴加氯代三苯甲烷的THF溶液，搅拌3h，制得4,4,4-三苯基-1-丁烯（Ⅲ），收率93%。 - Purifying Equipment for Coating Pretreatment Bath Solution
涂装前处理槽液的净化装置 - Present Situation of Cathodic Electrophoretic Painting Technology in China and Exploration on the Stability of Bath Solution. The electrophoretic coating has good bath stability and good property of foaming and antifoaming.
中国阴极电泳涂装现状及槽液稳定性的探讨该电泳涂料具有良好的槽液稳定性和起泡消泡性。 - Treatment of Heavy Metal Impurities in Cr Plating Bath and Regeneration of Waste Solution
镀铬液重金属杂质的处理及其废液的再生&应用DJ001大孔高强度阳离子树脂净化废浓铬液新技术 - Quick Determination of Chromic Anhydride in Chromium Electroplating Bath Solution
电镀铬液中铬酸酐含量的快速测定 - After chromic acid bath, such as Cr plating bath and chromate conversion solution, has been used for a long time, the quality of the products would be affected due to accumulation of metal ion impurities.
镀铬、钝化等铬酸槽液，经长期使用后，会积累金属离子杂质，影响产品质量。 - The passivating process and formulation of bath solution for zinc hot dipped coating with higher alloy content were investigated and discussed.
研究了合金含量较高的热浸镀锌层的钝化工艺及配方，探讨了钝化液组分对钝化膜性能的影响及钝化原理，检测了所研制钝化膜的性能。 - Emphases are given on the composition of bath solution, pulse plating and laser plating.
对脉冲、选择、激光等镀金方法作了展望。 - A promoter that can improve the quality of phosphating film and shorten the phosphating time was suggested and, a stabilizer that can stabilize the bath solution and reduce the sediment was obtained. On Quantity
优选复配了一种能提高低温条件下磷化膜质量及缩短磷化反应时间的促进剂，选择了合适的稳定剂，解决了槽液稳定性问题，减少了沉渣量 - The electrodeposition of low iron contained Zn-Fe alloy in sulfate bath solution was investigated by orthogonal experiments.
通过正交试验研究了酸性硫酸盐体系电沉积低铁含量的Zn－Fe合金镀层工艺，结果表明该体系的镀液配方简单，镀液稳定，操作简便，成本低廉。 - The effect of cathode current density, pH of bath solution and the bath solution temperature on the internal stress and anticorrosive property of 3-layer nickel electroplating has been studied, and the optimal technological conditions are determined via the comparative analysis.
研究了阴极电流密度、镀液的pH值、镀液的温度对三层镍镀层内应力及耐蚀性能的影响，并通过对比分析，确定了最佳工艺条件。 - Besides, the activation occurred rapidly, with a steady level achieved in 2 minutes after the replacement of bath solution.
激活作用发生迅速，在换液2分钟后激活水平就能保持稳定。